http://heat-ir-factory.com/en/tags/optimization/ Recent content in Optimization on Infrared Heating Factory Hugo en-us Tue, 07 Jul 2026 11:41:28 +0800 http://heat-ir-factory.com/en/posts/sidel-sbo-preform-heating-optimization/ Tue, 07 Jul 2026 11:41:28 +0800 http://heat-ir-factory.com/en/posts/sidel-sbo-preform-heating-optimization/ <p><img src="http://heat-ir-factory.com/images/39c83d3196bbeefc767ea49907038348.png" alt="Sidel SBO preform heating optimization"></p> <h2 id="introduction">Introduction</h2> <p>We built this 300mm infrared halogen tube for one reason: to fix the heating headaches on your SIPA rotary machine. The whole point is simple—get every heating station pulling the exact same power. When every lamp is on the same page, you finally say goodbye to hot spots and cold streaks. The kind that slow you down and cost you in scrap.</p> <h2 id="power-voltage-and-sizestraight-to-the-point">Power, Voltage, and Size—Straight to the Point</h2> <p>It runs at 400V, 2500W, and it’s 300mm long. That combo is how we pack in serious heat <a href="https://o-yate.net">density</a> without the power fading out across the bank. And that 300mm length? It lines up cleanly with the Sidel SBO preform zone, so your heating footprint is repeatable, station after station. But here&rsquo;s the reality check. A 2500W tube throws off a lot of heat in a tight space, so your machine’s cooling and airflow have to be up to the job. If you run it without enough cooling, you’ll end up cooking the electronics and shortening the life of the components.</p>